20 Chapter 2: Hardware installation
5. Once perfectly aligned with an empty slot, press the board
firmly but carefully into the connector.
6. Anchor the board by replacing the screw that you removed.
7. Follow the steps below to install the adapter bracket:
a. If present, remove the blank metal plate located at the
back of a slot next to the Matrox Meteor-II /Digital board;
do not discard this screw.
b. Install the bracket with the trigger and RS-232 input
connectors and fasten it with the screw you just removed.
c. Connect the cables to the 4-pin trigger connector and the
10-pin RS-232 connector on the Matrox Meteor-II
/Digital board (see figure below).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
