0
>DHCP 1
>
3.14 E Command
Routers and MSC-GCP2U32 only
Query or assign matrix routing changes echo. A value of 0 disables this feature. A value of 1 will cause all
matrix routing changes to be echoed in the form of an X command: “Xd,s[,l]”. Where 'd' is the destination
number, 's' is the source number and 'l' is the optional level number. This is useful for diagnostic purposes or
automation software which would like to receive synchronous matrix routing state updates.
NOTE:
Enabling this feature may slow down the system significantly during excessive matrix routing changes
(especially when enabled on the serial port). Also of note is that this option takes effect only while the system
remains powered (serial port) or for the duration of the connection (TCP/IP telnet sessions). This command is
not supported by the HTTP web command interface.
Command
Description
E
Query matrix echo enable.
E 0 | 1
Set matrix echo enable (0 to disable, 1 to enable).
Examples to query and then enable matrix echo
>E
0
>E 1
>
3.15 Firmware Command
Query the system firmware version.
Example
>Firmware
5.0.6
>
3.16 FrameIP Command
Query or assign the remote router IP address. Usually only used on Remote Panel devices or in conjunction
with the
RemoteSync Command
to create a dual router 3D system. Sets the IP address of the Router system
which the button panel will connect to and control (or which the router will synchronize to when using the
RemoteSync command). This can also be enabled on Router systems with a local button panel to configure the
Page 30 of 56
©
2013 Matrix Switch Corporation
www.matrix-switch.tv
