E00: Error message
>
00 will contain a 2 digit decimal error code.
3.6 Command argument values
Command arguments are shown in the Help command output surrounded by square brackets '[ARG]' or
parenthesis '(ARG)'. Square brackets indicate an optional argument and parenthesis indicate a required
argument. Any optional argument specified requires that all prior optional arguments are also specified.
Argument
Valid Range
Meaning
DEST
1-N
Destination number (N = Count of destinations)
SRC
1-N or 0
Source number (N = Count of sources), 0 acts as
mute (if supported).
LEVEL
1-N
Level number (N = Count of system levels)
PRESET
0-9
Preset number (preset 0 is special Startup preset)
IP
D.D.D.D
IP address string argument, specified as 4 decimal
digits from 0 to 255 separated by periods.
NETMASK
D.D.D.D
Network mask string argument, specified as 4
decimal digits from 0 to 255. Must be a valid
IPv4 netmask.
JSON
string
JSON formatted string, the structure of which
depends on the command. The JSON string
should be quoted in single quote characters when
specifying a JSON value in a command.
LABEL
string
A string label argument, max of 8 characters.
STR
string
A generic string argument (max length depends
on the command).
3.7 Error codes
This following table shows possible error codes which may be returned in response to commands.
Error #
Message
Description
E01
Token too long
A command name or string argument was too long.
E02
Invalid command
Invalid command name.
E03
Invalid argument
One or more invalid argument values.
E04
Invalid destination
Invalid matrix destination number.
Page 25 of 56
©
2013 Matrix Switch Corporation
www.matrix-switch.tv
