11
CHAPTER 5: TRoUblESHooTINg
5.3 TRoUblESHooTINg - EXCESSIVE PlAy IN HEIgHT ADJUSTMENT lEVER
EXCESSIVE PlAy IN PIVoTINg HEIgHT ADJUSTMENT lEVER
1) It is normal for the lever to exhibit a small amount of play before the upper drive arm is disengaged, but if the lever has excessive play (E),
if when the lever is pulled to its full extent there is a pronounced clicking noise when the upper arm is rotated, or if when the lever is pulled no
rotation is possible, follow the next steps.
2) Remove the right crank arm by removing 5 socket head cap screws with a 4mm Allen wrench, then remove the upper outside plastic cover
by removing 5 socket head cap screws with a 3mm Allen wrench.
3) Check the cable and cable sheath (A) for excessive wear (replace if necessary). If the lever still exhibits excessive play, tighten the
adjustment screw (B) clockwise until play is removed. Be careful not to over tighten the adjustment screw as the pivoting mechanism may not
fully engage and could lead to machine failure or injury.
4) If the cable / sheath do not have excessive wear, and tightening the adjustment screw does not resolve the issue, continue to Step 5.
