Operation
Page 6
3
Installation
3.1
Attaching the front sweeper
Danger!
Severe injuries to the operator or third parties can occur.
Switch off the tractor and remove the ignition key before mounting or dismounting the
sweeper attachment.
Depending on the design of the front hydraulic system, hook the front sweeper into the
tractor implement triangle or the two-point receptacle, in this process note that for first
attachment the connection pieces may need to be adjusted to the desired lift height.
For easier attachment and detachment of the front sweeper we recommend the two
supplemental
side parking supports with casters (special accessory)
.
3.2
Attachment of a SWE-HY 150
Depending on the tractor type the provided universal joint shaft may be too long. In this
case it must be shorted as described in the following steps.
Attention!
Damage can occur to the tractor or the implement.
Use the supplied universal joint shaft.
Note!
When mounting the universal joint shaft also comply with the original operating
instructions provided by the manufacturer of the universal joint shaft.
Shortening the universal joint shaft
Instructions for shortening and mounting the universal joint shaft
1. Pull the two halves of the universal joint shaft apart.
2. Mount one end of the universal joint shaft on the tractor.
3. Mount the other end of the universal joint shaft on the implement.
4. In the shortest work position, on one half of the
5. Universal joint shaft mark the piece that must be sawn off. (Picture 1)
Cut off the universal joint shaft guard to the marking. (Picuture 2)
6. Saw off the profile tube. Attention: The profile tub must be 10 mm longer than the
guard. (Picture 3)
Picture 3
Picture 4
Picture 1
EMBED
