Matan JetSet 3.2P Printer
58
User Manual
d. If there is any strange smell or you smell something burning, stop the machine
and check it.
e. Check operational parameters: tension, heating values.
5.1.3
Shut Down for Maintenance
1. Protect print heads (see Maintenance of Print Head).
2. Clean the printer with solvent. .
3. Push emergency stop SW.
5.1.3.1
Daily Maintenance
1. Check and empty the waste ink tank (located under the cleaning system.)
5.1.3.2
Weekly Maintenance
1. Dismantle carriage cover; use solvent to clean bottom of the cover.
2. Add lubricating grease to the rail, add oil to bell rail.
3. Set roller movement to 500mm before cleaning. Make sure feeding roller rotates
freely, use special rubber roller solvent PMA to clean roller. When done, use dry air
gun to blow dry.
4. Use PMA to clean dirt on the surface of roller, ensure there is no relative shift
between material and roller and keep the roller clean.
5.1.3.3
Monthly Maintenance
1. Clean the second ink tank on carriage.
2. Check and tighten fixed bolts on transmission shaft coupling and motor shaft
coupling
3. Check fixed screws of carriage and straight-line rail, check synchronous belt, if it is
loosened, tight it up again.
4. Check 6 outer hex head screws of Y shaft coupling.
5. Check screws on Y-Axis plank.
6. Check clamping screws on X-Axis motor, screw down bolt in the hole of crust, then
extend socket head screw into the hole, fasten the clamping bolt).
7. Check all cooling fans and motors.
8. Tidy up hard disk space of the computer, check for viruses.
9. Use air gun (air must be dry) to remove dust from the power supply box, electric
control board, and various electric boards.
