Matan JetSet 3.2P Printer
15
User Manual
Note:
If inducing material is to be added, do not stick two pieces onto the printer. Instead,
stick one piece on the ground and then feed it, making sure the stuck part is not pressed
between the pinch rollers.
To print on mesh, perform the following steps before feeding:
1. Turn off printer and remove the top platform board.
2. Close the ventilated cover and check if the waste ink tube is well connected.
3. Turn on printer.
4. The rest of the printing process is the same as normal printing.
To print double-face, perform the following steps:
1. Choose the right material.
2. Install the material and mark its installation position, then turn on the power and print.
During the printing process, the best method is to choose center printing.
3. After printing, use the drying icon to dry the printed media.
4. Next, feed the printed material on its other side. Make sure the installation position is
the same as you marked in “Step 2”
5. Choose mirror print. If the printing position is not right, adjust the position as follows:
a. Click the “Modify print” button. The Modify Print Position dialog box appears:
