Page | - 12 -
© Copyright Mastip Technology Limited. Information subject to alteration. V1.01 www.mastip.com
Temperature Controller METICOM CTI Series
5.
Log in the system (if required).
6.
Load a mold setup (if required).
7.
Checking the mold setup zone by zone on HMI.
8.
Correct any faults found during diagnostics.
9.
Touch “Run” to start the system.
10.
Check that the controller is functioning correctly.
IMPORTANT!
When switching off the system, wait 30 seconds before switching on again. System communication
issues can be experienced if the system is turned off and on incorrectly.
Chapter 4 Operator Interface
4.1 Main Interface
The main interface is used to monitor, log in the system and general operations.
4.1.1 Temperature Control
Icon Button Mode, 24-zone per page, Resolution 0.1 is not checked
I
c
o
n
B
u
t
t
o
n
M
o
d
e
,
4
2
-
z
o
n
e
per page, Resolution 0.1 is checked