Page | - 10 -
© Copyright Mastip Technology Limited. Information subject to alteration. V1.01 www.mastip.com
Temperature Controller METICOM CTI Series
2.4 Connecting the Power Input Cable (CTI-200 / CTI-300)
1.
Ensure the power input cable meets the international and local electrical code specifications.
2.
Remove the metal cover of the power input terminal block by removing screws around its
perimeter.
3.
Remove the plastic panel of the terminal block.
4.
Insert power input cable through access hole provided on the cover.
5.
Connect AC input cord to the input terminal block as shown on the inner side of cover, according
to the input voltage configuration you are attaching to.
6.
Connect the earth cord to the ground terminal beside the input terminal block.
7.
Cover the plastic panel on the terminal block.
8.
Take up excess slack in cable and secure with strain relief clamp.
9.
Mount the metal cover of the power input terminal block on the mainframe.
(1) (2) (3)
(4) (5)
CAUTIONS!
Service and installation of this equipment should only be performed by qualified service personnel
familiar with high voltage electrical circuits.
All international and local electrical codes must be followed when connecting this equipment.
Use O-type (ring) terminals on the power input cord connected to the terminal block.
Do not apply power to this cable or the unit when the back terminal block cover is removed.
Do not connect the power input cord to your power distribution system until the back terminal
block cover is securely in place.
Ensure the chassis has been earth grounded before applying power.