Portable Sampling Drive Operating Manual
Masterflex
3-3
Drive Operation
Section 3
Operation
1. Select Mode of Operation
Th
e unit can be operated in three diff erent modes:
A. Charge the internal battery, this disables all other functions.
B. Operate the drive on the internal battery power source.
C. Operate the drive on an external power source.
2. Operation Directions
To Charge the Internal Battery with AC/DC Power Supply/Converter or other
External Power Source:
CAUTION:
Fully charge the unit before using for the first time. Damage
to the internal battery can result if the battery is in a fully discharge
state and operation of the unit is attempted.
A.
Connect the supplied AC/DC Power Supply/Converter to drive
by lifting
EXTERNAL POWER INPUT (A)
r
eceptacle cover and inserting the 2.5 mm
coaxial power jack into the receptacle. (See Figure 1.)
DANGER:
Never apply AC voltages directly to the EXTERNAL POWER
INPUT receptacle on the front panel. The application of AC voltages
can result in injury and death of the operator and destruction of the
unit. Use only the AC/DC Power Supply/Converter supplied with the
unit to power unit from an AC source.
B.
Connect AC/DC Power Supply/Converter to an AC power source.
Place
the
Power Source Selection Switch (B), (EXTERNAL/BATTERY)
in the
“BATTERY”
position.
C.
Place the Mode of Operation Selection Switch (C), (RUN/CHARGE)
to the
“CHARGE”
position.
D.
The CHARGE indicator will illuminate.
E.
Charge the battery for 8–12 hours.
To Operate Pump With Internal Battery
DANGER:
The AC/DC Power Supply/Converter is rated for INDOOR
USE ONLY. DO NOT use the AC/DC Power Supply/Converter in an
outdoor environment to either charge the battery or power the drive.
Electrical shock, severe injury and/or death is possible if this warning
is ignored.
CAUTION:
Fully charge the unit before using for the first time. Damage
to the internal battery can result if the battery is in a fully discharged
state and operation of the unit is attempted.
A.
Place the Power Source Selection Switch (B), (EXTERNAL/BATTERY)
to
the
“BATTERY”
position.
B.
Place the Mode of Operation Selection Switch (C), (RUN/CHARGE)
to the
“RUN”
position.
!
!
