22
REPLACING THE CUTTING BLADES
– cont’d
Installing the cutting blades
– cont’d
6. When you have made the cutting
blade parallel to the front sole plate,
SLIGHTLY tighten the two outer blade
clamp screws (2 and 3).
7. Recheck the blade alignment and
make any necessary adjustments.
8. Completely tighten the MIDDLE blade
clamp screw first, and then completely
tighten the two outer blade clamp
screws.
9. Recheck the blade alignment to make
sure the blade did not move while
tightening the blade clamp screws. If
the blade requires realignment, repeat
steps #4 through #8.
10. Repeat steps #1 through #9 to install
the second cutting blade.
DANGER:
Make sure all three of
the blade clamp screws are fully
tightened before turning the tool ON.
When turning the tool ON, always have
the cutting blades and sole plate facing
away from your body. Loose cutting
blades will be thrown violently and
possibly cause serious injury.
11. Turn the tool ON. If there are any
unusual sounds or vibrations, turn the
tool OFF immediately and check for
misaligned or damaged cutting
blades.
ASSEMBLY AND OPERATING
ASSEMBLY AND OPERATING
!
Fig. 15
Summary of Contents for 54-6621-8
Page 12: ...12 CONTENTS ...
Page 24: ...24 EXPLODED VIEW ...
