19
CHANGING THE DRIVE BELT
– cont’d
9. Place the belt on the edge of the large
pulley (7).
10. Press downward on the belt about
1” (2.54 cm) from the pulley (8).
11. Rotate the pulley while pressing down
on the belt, moving your finger toward
the large pulley.
12. Repeat steps #10 & #11 until the belt
is fully installed on the large pulley.
NOTE:
Once the belt is fully installed on
the large pulley, rotate the pulleys and
check to make sure the belt is fully
engaged in ALL the grooves in BOTH the
large and small pulleys. If the belt is not
engaging all the grooves, it will damage
the tool and the belt will be ruined.
13. Replace the belt cover. Do not over
tighten the screws.
REPLACING THE CUTTING BLADES
WARNING:
Exercise extreme
caution when handling the cutting
blades. Use small pliers to remove and
replace the blades in the blade cylinder.
WARNING:
Remove the plug from
the power source.
Removing the blades
1. Place the tool on its back with the cord
end to your left hand side. It is best to
place the tool on a work bench that is
protected with an old towel to prevent
damaging the tool or blades.
ASSEMBLY AND OPERATING
!
!
Fig. 11
Summary of Contents for 54-6621-8
Page 12: ...12 CONTENTS ...
Page 24: ...24 EXPLODED VIEW ...
