20
REPLACING THE CUTTING BLADES
– cont’d
Removing the blades
– cont’d
2. Rotate the cylinder to expose one of
the blades (1) in the middle of the
opening between the front and rear
sole plates (Fig. 12).
3. Using the 30 mm blade screw wrench
(2), loosen all three blade clamp
screws (3) approximately 1 turn.
WARNING:
Exercise extreme
caution when using the wrench on the
blade clamp screws. The blade is
extremely sharp and may cause serious
injury if the wrench slips or you touch
the blade.
NOTE:
To loosen the blade clamp screws,
push the wrench AWAY from your body.
4. Carefully place the blade of a small
screwdriver (4) on the end of the
blade (5) and carefully and pry the
cutting blade away from the metal
blade stop (6) (Fig. 13).
NOTE:
Pry the blade away from the metal
stop at least 1/8” (3 mm).
5. Use a small pair of pliers (7) to pull on
the exposed end of the cutting blade
(8) (Fig. 14). Slide the blade
completely out of the blade clamp (9).
6. Use a soft dry brush to clean all debris
out of the cutting blade clamp.
7. Repeat steps #2 through #6 to remove
the second blade from the blade
cylinder.
ASSEMBLY AND OPERATING
!
Fig. 12
Fig. 14
Fig. 13
Summary of Contents for 54-6621-8
Page 12: ...12 CONTENTS ...
Page 24: ...24 EXPLODED VIEW ...