22
INSTALLING THE RIGHT ANGLE
ATTACHMENT
1. Remove the collet nut and the collet
from the motor shaft.
NOTE:
Engage the spindle lock button in
order to hold the spindle in place while
loosening and tightening the collet nut.
2. Remove the spindle nut (1) from the tool
by turning it counter-clockwise (Fig. 7).
3. Insert the short end of the drive shaft (2)
into the motor shaft (3) until the stopper (4)
comes into contact with the shaft.
4. Slide the collet nut (6) over the drive
shaft (5), and thread it onto the motor shaft
by turning the collet nut clockwise. Tighten
the collet nut using the collet wrench.
5. Remove the right angle attachment
adaptor (7) and the collar (8) from the right
angle attachment (9) by turning the collar
counter-clockwise.
6. Fasten the right angle attachment
adaptor and the collar to the tool (10) by
turning the right angle attachment adaptor
clockwise.
NOTE:
Tighten by hand only. Do not use
pliers or a wrench.
7. Insert the end of the drive shaft into the
hole in the right angle attachment (11).
ASSEMBLY AND OPERATING INSTRUCTIONS
Fig. 7
Summary of Contents for 54-4790-6
Page 13: ...13 CONTENTS 0 A D B C E F G H I J K L M...
Page 37: ...37 EXPLODED VIEW...
