25
INSTALLING THE SANDER ATTACHMENT
–
cont’d
3. Insert the short end of the drive shaft (4)
into the motor shaft until the stopper (5)
comes into contact with the shaft.
4. Slide the collet nut over the drive shaft,
and thread it onto the motor shaft by
turning the collet nut clockwise. Tighten
the collet nut using the collet wrench.
5. Remove the sander attachment adaptor
(6) and the collar (7) from the sander
attachment by turning the collar counter-
clockwise.
6. Fasten the sander attachment adaptor
and the collar to the tool (8) by turning the
sander attachment adaptor clockwise.
NOTE:
Tighten by hand only. Do not use
pliers or a wrench.
7. Insert the square end of the drive shaft
(9) into the hole in the sander attachment
(10).
NOTE:
Rotate the drive shaft while
pushing the sander attachment onto the
adaptor until the square end of the drive
shaft is inserted into the corresponding
square in the sander attachment.
8. Once the drive shaft is inserted fully into
the sander attachment, secure the sander
attachment to the adaptor by turning the
adaptor collar clockwise onto the sander
attachment threads (11).
NOTE:
Tighten by hand only. Do not use
pliers or a wrench.
ASSEMBLY AND OPERATING INSTRUCTIONS
Fig. 9
Summary of Contents for 54-4790-6
Page 13: ...13 CONTENTS 0 A D B C E F G H I J K L M...
Page 37: ...37 EXPLODED VIEW...
