ASSEMBLY AND ADJUSTMENTS
14
TOOLS NEEDED FOR ASSEMBLY
• Adjustable wrench
• Screwdriver
• Hammer and block of wood
BASE TO COLUMN (Fig. 1)
1. Set the base (1) on the floor.
2. Place the column tube (2) on the base (1), align
the column support holes with the base holes.
3. Install a bolt M8 x 25 (3), a flat wahser M8 (4) and
a spring washer M8 (5) in each column support hole
and tighten with the wrench.
TABLE TO COLUMN (Fig. 2–4)
1. Insert the rack (1) into the geared groove of the
table support (2). Make sure the worm shaft (3) on the
inside of the table support is engaged with the teeth
of the rack. The table support should sit at the centre
of the rack.
2. Slide the table support and rack assembly (1, 2, 3)
down together onto the column. Insert the bottom
edge of the rack into the lip (4) of the column support.
HOLD IN THIS POSITION until step 3 is completed.
3. Place the collar (5) bevel side down over the rack.
Tighten the set screw (6) with the 3 mm Allen wrench
to hold the rack in position.
Note:
Make sure there is enough clearance to allow
the table to rotate around the column. The collar must
sit loosely over rack and not angled on the column.
To avoid column or collar damage, only tighten the set
screw enough to keep collar in place (Fig. 3).
4. Insert the table support crank handle (7) into the
worm gear shaft on the side of the table support (8).
Make sure the set screw (9) is aligned on the flat of
the shaft and as close to the table support as possible.
Tighten the set screw (Fig. 4).
5. Position the table in the same direction as the base,
and tighten the column lock handle (10).
V. Assembly and adjustments (continued)
Fig. 4
WARNING:
To reduce the risk of injury, never
connect plug to power source outlet until all assembly
steps are completed.
10
8
9
7
Fig. 1
1
5
3
4
2
Fig. 3
6
5
Fig. 2
1
3
2
4
