TABLE ADJUSTMENTS TO RAISE OR
LOWER (Fig. 15)
1. Raise or lower the table by loosening the column
lock handle (1) and turning the crank handle (2) until
the table is at the desired height.
2. Tighten the table lock handle (1) before drilling.
3. Rotate the table around the column by loosening
the column lock handle (1) and turning the table
around the column to the desired position.
4. Tighten the lock handle before drilling.
TO TILT THE TABLE (Fig. 16)
The table can be tilted from 0 to 45° to the left and right.
1. Loosen the bevel lock bolt (1) with a wrench.
2. Tilt the table (2) to the desired angle, using the
bevel scale (3) as a basic guide.
3. Re-tighten the bevel lock bolt (1).
4. To return the table to its original position, loosen the
bevel lock bolt. Realign the bevel scale (3) to the 0°
setting.
5. Tighten the bevel lock bolt (1) with the wrench.
TO SQUARE THE TABLE TO THE HEAD
(Fig. 17)
1. Insert a 3" (7.6 cm) drill bit (1) into the chuck (2) and
tighten.
2. Raise and lock the table (3) about 1" (2.5 cm) from
the end of the drill bit.
3. Place a combination square (4) on the table as
shown. The drill bit should be parallel to the straight
edge of the square.
4. If an adjustment is needed, loosen the bevel lock (5)
with a wrench.
5. Square the table to the bit by tilting the table.
6. Tighten the bevel lock bolt (5) when square.
Fig. 15
Fig. 17
1
2
19
V. Assembly and adjustments (continued)
Fig. 16
2
1
3
2
1
3
4
5
