Installation & Operation Manual | HORIZON3D
©
MASTERIMAGE 3D, Inc.
34
7.2.4. IMB Configuration Settings
Projector configuration settings when using an IMB (Integrated Media Block) or IMS
(Integrated Media Server) are slightly different; an example of this is given below for a Christie
projector and a Doremi IMB/IMS. The changes are highlighted in bold; other projector/IMB
manufact
urers’ configurations may vary slightly. Contact the respective manufacturers for
specific information.
Config. 1
Input = IMB-Internal
Data Format = 4:4:4 (RGB)
Source File = Based on content
reso aspect ratio (1998x1080
Flat, 2048x858 Scope, etc.)
Screen File = Site-specific (typically
Flat or Scope based on content)
Use PCF = not selected (unchecked)
Lamp File = Site-specific
ILS File = Site-specific
Auxiliary Lens = Site-specific
–
Selected if Anamorphic Lens or WCL
needed, otherwise unselected
Config. 2
Measured Color = Site Specific
(Create on-site)
Target Color =
DC28_DCI_XYZE_314_351
Color Space = Unity RGB
Gamma = Gamma 2.6
LUT-CLUT = Linear_9x9x9
Scan Type = Progressive
LD Bypass = Selected (this sends
IMB output directly to ICP. This is
required if no LD is installed)
3D Control
Enable 3D = Selected
3D Sync Input Mode = Use
Selected Input Port (polarity = true)
Frame Rate N:M = 6:2
L/R Display Sequence = Left (L1R1
L2R2)
3D Sync Polarity = True (If left/right
eye images swapped set to Inverted)
Dark Time = 350
Output Delay = -100
Phase Delay = 0
Barco Series II projectors have a pre-installed 3D configuration file for the settings required
by the CLARITY3D system. It is possible to select this file rather than making fully manual
entries, but editing of Dark Time and Output Reference Delay would be required.
