Installation & Operation Manual | HORIZON3D
©
MASTERIMAGE 3D, Inc.
14
J
K
L
M
N
O
P
Q
R
3.
Side Panel | Switch & Port
J. DIP switch:
To change Sync polarity (True or Invert) & 3D
Position (UP or DOWN).
K. Ethernet Port:
Used for Automation, Alignment, Monitor
Program & Firmware Upgrade of Control Panel.
L. GPIO/TTL Port:
Connected between HORIZON3D and DLP
Projector for 3D SYNC Input and automation function.
M. Actuator Port:
Connected between Control Panel and lift-column
actuator to move the Optical Head between 3D position or 2D
position.
N. DC Port:
DC (+24V) Power Port.
(*Note: If the Actuator Cable is connected to the Actuator port, do
not connect the DC power adaptor to the Control Panel, connect to
the Lifting Column)
O. 7-Segment LED:
Used for
Sync Frequency or Error Codes display.
P. 3D Button:
Used to move the Optical Head to 3D position and to
activate 3D operation.
Q. 2D Button:
Used to move the Optical Head to 2D position and to
stop 3D operation.
R. RUN Button:
Activates
3D operation.
