Installation & Operation Manual | HORIZON3D
©
MASTERIMAGE 3D, Inc.
22
6.2.
System Alignment
6.2.1. Adjusting Optical Head Assembly Position
Turing the Tilt Knob clockwise
Adjusting the 3D position slightly
1
2
To achieve the best 3D display, the Optical Head must be installed properly and aligned optimally.
1.
Adjust the Tilt Angle Stage by turning the tilt knob clockwise and make sure that the Optical Head Assembly is positioned
perpendicular to the central light path.
2.
If necessary, adjust the 3D position height slightly. (Adjusting 3D position refer to section 6.1.4 Setting 3D Position
3.
Check if Optical Head Assembly is positioned perpendicular to the central light path and images are properly in viewing
area.
4.
Repeat Step1, 2 and 3 until the Tilt Angle and 3D position are so satisfied.
5. If satisfied, fix the tilt angle and save the 3D position.
Check if Optical Head Assembly is installed perpendicular to
the central light path
Ɵ=90°
Check if 3D images are properly within viewing range
3D images
Do not look directly into the projector lens
The extremely high brightness can cause permanent eye damage.
