![background image](http://html.mh-extra.com/html/massoth/dimax-100a/dimax-100a_manual_1735954004.webp)
2.2. LGB
®
MTS III Update
Connect the LGB
®
MTS III (55006) central station to a transformer. The PC-Module will be supplied with power
by the bus cable which connects to the DiMAX terminal of the central station.
Start the „DimaxUpdate V11“ program and follow the instructions on the screen.
2.3. eMOTION Decoder Update
An AC or DC power supply is required for updating MASSOTH eMOTION Digital Decoders. Note the specificati-
ons in chapter 4. Connect the track terminals of the decoder to the right hand terminal of the PC-Module. An
electrical load (preferably a motor) must be connected to the decoder to receive a programming confirmation.
Start the „DimaxUpdate V11“ program and follow the instructions on the screen.
Note: Only Massoth eMOTION Decoders with version 2.0 and higher may be updated! Check the deco-
der's firmware version by reading CV7.
Programming must be accomplished via the programming track terminal of the PC-Module. Thus the decoder
may be updated even if it is installed in a locomotive.
NOTE: The data volume transferred is tremendous. An optimum track contact during this procedure is a
must.
We recommend to utilize the loco's power socket if available or the Massoth Rolling Road. The update
procedure starts with an extensive test of the communication line. In case the update shuts down prematurely, a
better contact must be provided.
DiMAX 100A PC Module
– 8175001 3
Illustration 2: Updating a LGB
®
MTS III Central Station