11
There are three ways to program your remote control:
• Using a pre-programmed 3-digit code
• Automatic search method
• Teaching method
Programming your remote control using the pre-programmed
3-digit code allows you to configure all the buttons at the same
time simply by entering the device’s 3-digit manufacture code.
These codes are included as an Appendix to this manual, select
the one that corresponds to the remote control you have.
The automatic search function provides all the codes included
in the remote control, one at a time.
The teaching method allows you to “teach” a function from
another remote control to your remote control, one button at
a time.
IMPORTANT NOTE
For all the following methods, when you are in programming
mode, the “MODE” button corresponding to the device (AUX,
DVD, AUD, TV, STB) you want to pair with your remote will light
up for 30 seconds. If you don’t press a button within this delay,
this light will automatically turn off. You will exit programming
mode and you will have to start over.
A. USING A PRE-PROGRAMMED 3-DIGIT CODE
Step 1
Turn on the device you want to pair your remote with.
Step 2
Simultaneously press the “MODE” button corresponding to
the device (AUX, DVD, AUD, TV, or STB) and the “OK/SEL” button
for 3 seconds. The light of the mode button selected will light
up for 30 seconds indicating that the remote control is ready
to be programmed.
Step 3
Point the remote control at the device you want to pair your
remote with and enter the device’s 3-digit manufacturer code.
Note that the device will turn off if you have entered the
correct code.
Step 4
After entering the correct code corresponding to your device and
after it turns off, press the “POWER” button to turn the device
back on again. Then, press the “VOL +”, “VOL -“, and “MUTE”
buttons for the TV mode button (or “PLAY” and “STOP” for the
DVD mode button) in order to make sure they function properly.
If any of the buttons don’t work, repeat step 3 by using the 3-digit
code in the code list until you find the best code for your device.
Step 5
When you find the code corresponding to your device, save it by
pressing the “MODE” button that is lit up. It should blink twice to
confirm that the code has been properly saved.
Repeat steps 1 to 5 for each of your devices.
B. AUTOMATIC SEARCH METHOD
Step 1
Turn on the device you want to pair with your remote.
Step 2
Simultaneously press the “MODE” button corresponding to the
device (AUX, DVD, AUD, TV, or STB) you want to pair with your
remote and the “OK/SEL” button for 3 seconds. The mode button
selected will light up for 30 seconds indicating that the remote
control is ready to be programmed.
Step 3
Point the remote control at the device you want to pair with your
remote and press the “CH +” or “CH -” once your device turns off.
Step 4
Make sure all the buttons function properly (similar to method
A). If some of the buttons do not function properly, repeat step 3
by using the “CH +” or “CH -” in order to find the right code.
Step 5
When you find the code corresponding to your device, save it by
pressing the “MODE” button that is lit up. It should blink twice in
order to confirm that the code has been properly saved.
Programming your remote control
Summary of Contents for A-140 Amino
Page 14: ...10 ...
