Mase MPL 10 CX, Use And Maintenance Manual

Page: 26 / 44

- 26 -
GENERATORS
MPL SX - CX
6.7 Table of scheduled operations
OPERATION HOURS
Check the level of the oil in the sump 10
Check belt tension 50
Clean the air filter 100
Replace the oil sump 150
Check the level of the electrolytes
and thebattery charger status
150
Replace the fuel filter 300
Replace the oil filter 300
Replace the alternator belt 500
Regulate the play in the rocker lever 600
Check the injectors 600
Calibrate and clean the injectors 600
Check alternator bushes 1200
Partial overhaul 2500
General overhaul 5000
6.8 Troubleshooting
The starter motor turns but the main engine does not
cut in.
- Make certain there is fuel in the tank (refill).
- Make certain that the Stop solenoid valve is powered
(contact the Service Centre)
- Make certain that the fuel pump is functioning (contact
the Service Centre)
The control panel does not cut in when the ignition
key is turned.
- Check the protection fuse (replace)
- Check the connection cable and electrical connectors
(reconnect)
- Make certain that the battery is operative (recharge or
replace)
The unit cuts out during operation.
- Check whether the protection has been activated and
the warning light is on (remove the cause and try to start
up again)
- Make certain there is fuel in the tank (refill)
The engine is running irregularly.
- Check the fuel filters (replace)
- Make certain that the fuel pump is operating properly
(replace)
- Check calibration of the injectors (contact an Author-
ized Service Centre)
WIRING DIAGRAM LIST MPL 10- 15 SX- CX (M)
1 Socket 3 p + n + e 32A
2 Socket 2 p + e 16 A
3 Output terminal
4 Circuit breaker - earth fault device
5 Commutator
6 Voltmeter
7 Frequency meter
8 Hour counter
9 Ampermeter
10 Stator
11 Rotor
12 Diode bridge
13 Starter
14 Starting key
15 Cutout module
16 Connector
17 Emergency stop button
18 Oil pressure indicator
19 Air thermostat
20 Fuel float
21 Solenoid valve
22 DC alternator
23 Battery
WIRING DIAGRAM LIST MPL 10-15 SX- CX (NSM)
1 Socket 3 p + n + e 32A
2 Socket 2 p + e 16 A
3 Output terminal
4 Circuit breaker - earth fault device
5 Commutator
6 Voltmeter
7 Frequency meter
8 Hour counter
9 Ampermeter
10 Stator
11 Rotor
12 Diode bridge
13 Starter
14 Starting key
15 Cutout module
16 Connector
17 Emergency stop button
18 Oil pressure indicator
19 Air thermostat
20 Fuel float
21 Solenoid valve
22 DC alternator
23 Battery
24 Automatic Voltage Regulator
UK