User Manual 7
3.
Insert a male 120
Ω
XLR termination plug in the output of the last fixture on the link.
Setting control protocol and address
One of the operating modes shown below must be selected. Factors to consider when selecting a mode will depend on your
controller and are discussed in the next section. Maximum flexibility is provided in mode 4.
Each fixture must be assigned its own channels to receive instructions from the controller. The address, also known as the start
channel, is the first channel used. Addresses are independent of the physical link: they may be set in any convenient order.
Two MAC 600/E’s may share the same address; however, they will receive the same instructions and independent control will
not be possible.
Mode
Martin
DMX 1
DMX 2
DMX 3
DMX 4
Movement speed
Vector
Tracking
Tracking and/or Vector
Pan/tilt resolution
16 bit
8 bit
16 bit
8 bit
16 bit
Channels
2
10
12
12
14
1.
Switch on the MAC 600/E.
2.
You may push
[MENU]
and
[ENTER]
simultaneously to disable pan and tilt reset. This is handy if you want to
change settings while the MAC 600/E is in a flight case. As the fixture does not run through the entire reset
procedure, error messages will be displayed. This is not a fault with the fixture. The reset procedure can take
2 - 3 minutes.
3.
Press the
[MENU]
key once, and then press the
[
↑
]
or
[
↓
]
keys repeatedly until the display shows
PSET
. Press
[ENTER]
to confirm.
4.
Press
[
↑
]
or
[
↓
]
until the desired protocol, as shown in the above table, appears on the display. Press
[ENTER]
to confirm.
5.
Press
[
↑
]
or
[
↓
]
repeatedly until the display shows either
dAdr
or
MAdr
, depending on whether you wish to
select a DMX address or Martin address, respectively. Press
[ENTER]
to confirm.
6.
Press
[
↑
]
or
[
↓
]
repeatedly until the desired address is displayed. Press
[ENTER]
to confirm.
Press [MENU] to return to the main menu. The address is displayed. Address and protocol settings are saved when the power
is switched off.
Installing the snoot (optional)
1.
Bend the tabs 90°.
2.
Bend the ring into a circle with the tabs on the outside. Weave the end tab through the 3 slots.
3.
Insert the tabs between the 3 pairs of pins between the lens and the head cover.
1
2
3
s e c t i o n 3
OPERATION