User Manual 21
a p p e n d i x b
ERROR MESSAGES
Display readout
Appears if...
What to do
AUTO
(Automatic protocol
detection error)
... automatic protocol detection is
enabled but the protocol (Martin/DMX)
cannot be determined because there is
no control data.
•
Verify that the controller is
sending and the serial link is
properly connected.
LERR
(Lamp error)
.... the lamp doesn’t ignite within 10
minutes of receiving the ‘Lamp ON’
command. Likely reasons are a missing
or defective lamp, or insufficient AC
voltage.
•
Check the lamp and check that
the mains setting of the fixture
matches the mains supply.
MERR
(Memory error)
...the EEPROM memory cannot be read.
•
Contact Martin service
personnel for assistance.
CSER
(Check-sum error)
...a software upload is not successful
•
Upload software again, see
page 19.
****
... there is no communication between
the control module and motherboard.
This readout appears briefly when
switching on the fixture.
•
•
Check fuses on motherboard
and replace accordingly.
Check that ribbon cable
between control module and
motherboard is connected
properly.
ShER
(Short error)
... the fixture detects that the lamp is ON
but no ‘Lamp ON’ command has been
received. This can occur if the lamp
relays are stuck in the ON position or if
the lamp-power feedback circuit has
failed. You can still operate the fixture
but may not be able to remotely switch
off the lamp.
•
Contact Martin service
personnel for assistance.
HoT
(Hot lamp)
... you attempt to strike the lamp within 8
minutes after having switched it off. The
fixture will store the ‘Lamp ON’
instruction and strike the lamp once the 8
minutes have elapsed.
•
Wait until the lamp strikes.
bTER
(Base temperature error)
HTER
(Head temperature error)
...there is a malfunction in the base or
head temperature sensing circuit.
•
Contact Martin service
personnel for assistance.
FbEP
(Feedback error pan)
FbET
(Feedback error tilt)
FbER
(Feedback error pan/tilt)
...pan (
FbEp
), tilt (
FbET
) or both (
FbER
)
feedback circuits are malfunctioning. It
will still be possible to operate the fixture,
though it goes into a “safe” mode where
maximum speed is reduced, thus
preventing the fixture from losing track of
its home position (losing step).
•
Contact Martin service
personnel for assistance.
PAER
(Pan time-out)
TIER
(Tilt time-out)
...pan and/or tilt indexing circuit is
malfunctioning. The fixture will, after the
time-out, establish a mechanical stop,
and continue to work normally.
•
Contact Martin service
personnel for assistance.