© Martin Engineering GmbH
24
M3289UK-01/17
Installation
5.2.8
Tensioning the secondary cleaner
1.
Loosen the clamping screws (1, Fig. 12).
2.
Loosen the lock nut (4, Fig. 12).
3.
Loosen the securing nut (2, Fig. 12).
4.
Turn the adjusting screw (3, Fig. 12) anticlockwise till the
cleaning elements are pressed against the conveyor belt.
NOTE
Perform the following steps carefully so that the MARTIN
®
brush
cleaner achieves the desired cleaning result.
CAUTION! RISK OF DAMAGE!
Excessive or uneven tightening of the conveyor belt cleaner on the
conveyor belt can cause material damage.
Only adjust conveyor belt cleaner according to specifications and
also ensure that the adjustments on both sides are the same.
NOTE
After the installation, the secondary cleaner must be adjusted to
the conveyor belt. In this, the cleaning elements should not be
pressed more than 3-4 mm against the conveyor belt.
NOTE
To avoid canting, both tensioners should be moved
simultaneously.
