![Martin Brush Cleaner Installation Instructions Manual Download Page 32](http://html1.mh-extra.com/html/martin/brush-cleaner/brush-cleaner_installation-instructions-manual_1732867032.webp)
© Martin Engineering GmbH
30
M3289UK-01/17
Maintenance
6.
If the cleaning elements have a diameter of less than 90 mm,
these must be replaced in accordance with the instructions in
Section 6.3.
7.
Clean all the warning labels. Replace illegible warning labels
immediately. Warning labels can be purchased from Martin
Engineering or a contracted dealer.
NOTE
Take the corresponding parts out of service if any indications of
functional disturbances are noticed. Contact Martin Engineering or
one of its representatives for support. Do NOT start up the
conveyor system until the cause of the problems has been
recognised and eliminated.
CAUTION! RISK OF DAMAGE!
Cleaning elements may not abrade under the height of the fixing
screws on the shaft or must still have at least an outer diameter of
90 mm, otherwise this can lead to serious material damage.
Inspect cleaning elements regularly and replace in time!
CAUTION! FLYING OBJECTS!
Forgotten tools or installation parts can fall off of the running
conveyor belt and cause minor injuries and property damage.
Always remove any tools from the installation site and conveyor
belt upon completion of the installation work before switching on
the power supply.
NOTE
The angled gearbox motor must be checked at least once a
month for oil level, oil change, leaks, etc. Observe instructions in
the manufacturer documentation on maintenance intervals!
NOTE
The bearing of the angled gearbox motor must be checked at least
once a week for lubrication, damage, running performance, etc.
Observe the information in the manufacturer's documentation
supplied with the device!