Martela Oyj
Takkatie 1
FI-00371 Helsinki
[email protected]
3.5 User guide for handswitch with display
TDH5
Normal operation
• TDH5 is connecting to control box. Press any button. 3-digits display shows current desk height in
centimeters.
• Press
or
button to adjust the desk height.
• When no button has been pressed for 10 seconds, display goes off. Press any button to light up the
display again.
• When no button has been pressed for 30 seconds, the system goes to <0.1 W standby mode. Long
press any button to wake the system up. Display shows desk height again.
Reset
• Press both
and
buttons at the same time for 3 seconds. Continue pressing the buttons
until both columns are in the lowest position. When the reset is complete, the control box makes a
beep and the buttons can be released.
• When conducting reset, the display shows ”000” in last 100 mm stroke. When the reset is complete,
the display shows starting height again.
• If releasing
and
buttons before the display s
hows ”000”, the desk goes back to nor-
mal operation.
• If releasing
and
buttons after the display shows ”000”, the user has to finish the reset
to go back to normal operation.
• Reset is necessary at first operation of the desk.
Change of the starting height
• The default starting height is 65 cm.
• To adjust the starting height, press
button to go to the lowest position of the desk. At the
lowest position, press
button again for 5 seconds, display starts flashing for 10 seconds.
• During the 10 seconds, press
or
buttons to adjust the starting height in centimeters.
After 10 seconds, the display stops flashing and the preferred starting height is shown and has been
stored.
Memorise position
• TDH5 supports 4 memory positions.
1. Operate the
desk to preferred height.
2. Press any of together with or for 2 seconds to store the current height. Display shows P1/P2/P3/P4
when the position has been stored.
3. When the position is stored, press the button until the table stops (reaches the stored height).
