Marshall Electronics V-R902DLW, Operating Instructions Manual

Page: 5 / 36

5
Installation and Initial Setup
■
Unpacking
Carefully unpack the V-R902DLW monitor and verify that the following items are included:
• V-R902DLW Monitor
• V-PS12V-5A-2 Power Supply
• Operating Instructions
Inspect the unit for any physical damage that may have occurred during shipping. Should there be any damage, immediately
contact Marshall Electronics at (800) 800-6608. If you are not located within the continental United States, call +1 (310) 333-
0606.
■
Installation
The V-R902DLW can be mounted in any standard EIA 19” equipment rack. The attached rack ears can be angled to provide the
user control over the viewing angle. Adequate ventilation is required when installed to prevent possible damage to the
monitor’s internal components. Please see the
Dimensions section for more information.
■
Connections, Power-On and Initial Setup
Plug the power supply into an AC power source (100-240 V @ 50/60 Hz). Attach the Power connector to the back of the monitor.
Connect the required cables for video signal input and output. (Power must be applied to the V-R902DLW for the active loop-
though output to be activated.) The monitor defaults to ‘ON’ when power is supplied. Video will automatically be detected and
displayed on the screen.