Marshall Electronics V-R902DLW, Operating Instructions Manual

Page: 16 / 36

16
■
HDMI CSC Auto (HDMI input only, via the DVI-I interface)
The HDMI CSC Auto setting is used to accommodate newer HDMI interfaces that send colorspace signaling in the HDMI data
stream. If this setting is set to On, the monitor will automatically determine which colorspace setting to use. If this setting is set
to Off, or your HDMI signal does not contain colorspace signaling, the DVI-D CSC Mode described above will determine the
colorspace configuration.
Audio Config Submenu
■
Mute
The Mute function disables audio output from Headphone output on the IMD 3G monitor. This will not control the Line Out
level of the monitor, only the Headphone output.
■
Volume
The Volume control determines the output level for the Headphone out on the IMD-3G monitor.
■
Audio Delay
The Audio Delay function applies a delay to the Audio Metering and audio output. Use the function to select a delay between
000 and 015 (in terms of fields, or frames if the signal is progressive).
■
Left Ch. Select
Use this setting to select which of the 16 possible channels you would like to play on the Left side of the stereo output.
■
Right Ch. Select
Use this setting to select which of the 16 possible channels you would like to play on the Right side of the stereo output.