Marquis 720 FLY, Owner'S Manual

Page: 44 / 126

DaNgEr
DO NOT HANG THE END OF THE SHORE POWER CORD INTO THE WATER. NEARbY SWIMMERS OR PASSENGERS CAN
bE KILLED OR SERIOUSLY INJURED FROM THE SURROUNDING ELECTRICAL FIELD.
DaNgEr
DEATH OR SERIOUS INJURY MAY INCUR bY INCORRECTLY SERVICING THE AC ELECTRICAL SYSTEM. ONLY TRAINED
ELECTRICIANS SHOULD SERVICE THE YACHT’S AC ELECTRICAL SYSTEM.
bEFORE ATTEMPTING TO SERVICE THE AC ELECTRICAL SYSTEM, ALWAYS:
DISCONNECT THE YACHT FROM THE SHORE POWER SOURCE •
SHUT OFF THE GENERATOR •
DISAbLE THE INVERTER •
SHORE POWER CONNECTION
SHORE POWER CONNECTION PROCESS:
sTEP 1: Switch OFF the Water Heater circuit breaker, located on the AC BUS 1 Distribution Panel, in the Engine Room
Aft .
DO NOT
switch the breaker ON again until the fresh water system has been filled, pressurized, and primed .
sTEP 2: Switch OFF both SHORE and GENERATOR circuit breaker groups, located on the AC BUS 1 Distribution Panel,
in the Engine Room Aft .
sTEP 3: Switch OFF the AC MAIN circuit breaker group(s), located on the AC BUS 1 Distribution Panel and AC BUS 2
Distribution Panel, in the Engine Room Aft .
NOTE:
Switch off the AC MAIN circuit breakers before connecting to the shore power to prevent arch
ing and burning of the shore power cord receptacles . Disconnecting will protect the electrical
equipment on board from rapid ON/OFF current connections, which may occur during the con
nection process .
sTEP 4: Locate the 50’ shore power cord . Connect the female end of the cord to the yacht’s shore power receptacle,
located at the PORT Aft Stairway .
sTEP 5: Connect the female end of the cord(s) to the yacht’s shore power receptacles(s) . The receptacles(s) are located
on the PORT transom . If the optional forward shore power receptacle(s) are equipped, they are located on the
STDB forward side deck .
sTEP 6: Secure the nonmetallic threaded locking ring to the yacht’s shore power receptacle . Securing, prevents the cord
from being accidentally disconnected, and prevents arcing due to a gap between the cord plug and the receptacle .
sTEP 7: Unthread the access cap and lift cap up . Pay out cord as needed using the Cable Master Switch .
sTEP 8: Switch the External Cord and Cablemaster circuit breaker OFF, installed in the source box at the shore power
station, located in the Engine Room Aft STBD .
sTEP 9: Plug the male end of the shore power cord into the shore power source outlet .
sTEP 10: Secure the nonmetallic threaded locking ring to the shore power source outlet . Securing the locking ring prevents
the cord from being accidentally disconnected and from arcing due to a gap between the cord plug and the
outlet .
7027 • A2 07/11 32
aC e
leCTriCal
s
YsTem
s
eCTion
3