Marquis 720 FLY, Owner'S Manual

Page: 102 / 126

90 7027 • A2 07/11
m
ainTenanCe
s
eCTion
7
A teak table should be oiled monthly to keep the wood from drying out . When the table is not in use, it should be kept covered with a
water resistant breathable cover to protect it from the elements .
The exterior teak table is an optional item; the warranty period for the table is the same as the yacht’s limited warranty period . The
warranty period for both items start from the date of delivery to the original owner .
f
inisH
r
epair
p
roCedUres
The following process is only a repair procedure . Items repaired may not be restored to their original pristine condition . The process
will allow damaged areas to be repaired with amazing results .
WOOD FINISH bUFFING PROCEDURE
Clean surface with 3M cloths (3M #23589) . 1 .
Identify the problem area and the sand affected area with 1200, 1500 & 2000 grit sandpaper . 2 .
Clean area with alcohol, and confirm that area is ready to be buffed, if not, repeat steps 1 - 3 3 .
Buff with a small amount of 3M Extra Cut Compound using the 3M ‘Perfect It’ Buffing Pad #05737 (White Color) . 4 .
Apply a small amount of 3M ‘Finesse It’ Final Finish Compound using the 3M ‘Perfect It’ Buffing Pad #05725 (Black/Grey 5 .
Color) .
Repeat if necessary, if swirl marks appear .
6 .
Clean up area with 3M cloths (3M #23589) and 3M ‘Clean and Shine’ . 7 .
REMOVING DENTS IN WOOD FINISH
Apply water to the wood using a wet rag . 1 .
Apply heat to the wood, using either an iron or a hand steamer . 2 .
Sand area with 400 grit sandpaper . 3 .
Replace color with Triclad Water Base Stain 13-9810 . 4 . Be careful not to get the material outside of the sanded area (doing so
will result in a dark ring around the patch) .
Apply Poly Sealer TH-20: 3 to 4 coats with a paintbrush
5 .
Allow 15 minutes between coats •
Allow 2 hours to dry . •
Apply Poly Topcoat SC-4185: 3 to 4 coats with a paintbrush . 6 .
Allow 15 minutes between coats •
Allow at least 8 hours to dry . •
Level patch with a razor blade and sand with 1200, 1500 and 2000 grit sandpaper, following buffing procedure on the previous 7 .
page .
FILLING DENTS IN WOOD FINISH
Locate the correct Burn Sticks color to match finished wood . 1 .
Apply Burn in Balm around area of patch to protect wood from heat . 2 .
Melt material into dented or chipped area . 3 .
Level the patched area with an iron and remove any excess Burn Stick material . 4 .
Scuff area with 600 grit sandpaper . 5 .
Apply Poly Sealer TH-20 over affected area: 3 to 4 coats with a paintbrush . 6 .
Allow 15 minutes between coats •
Allow at least 8 hours to dry . •
Level patch with a razor blade, and sand with 1200, 1500 & 2000 grit sandpaper, following buffing procedure on the previous 7 .
page .