MARLO MATD 9500 XT, Manual

Page: 8 / 71

Page
5
INSTALLATION INSTRUCTIONS
WATER DEALKALIZER
GENERAL INFORMATION
1. Minimum operating pressure is 25 psi.
If pressures less then 25 psi are encountered, a pump must be installed.
Note
: The control valve will not operate correctly if feeding into an atmospheric tank. A
pressure control devise must be added to the outlet to maintain the minimum pressure.
2. Maximum operating pressure is 120 psi.
If pressures greater then 120 psi are encountered, a pressure regulator must be installed.
3. Power requirements are shown on inside cover of the control valve.
4. Standard units are designed to
condition
unheated water not to exceed 100 ° F.
Special valve assemblies are available to handle heated water supplies exceeding 100 ° F.
Consult factory if applicable.
5. Each
dealkalizer
tank is shipped with distributor manifold and control valve preassembled.
Take care when uncrating and erecting so that no items are damaged.
6. The distributor assembly has been shipped inside the fiberglass mineral tank.
Check to make sure that there is no damage to the riser pipe, baskets, laterals, or hub.
8
. Freeboard is the distance between the surface of the resin and the top of the tank.
9
. Regeneration waste volume is the total gallons of water that is discharged per regeneration.
1
0
. The water meter has a flow range of
1
.
5
to
75
gpm with accuracy ± 5%.
1
1
. On continuous flow rates pressure loss does not exceed 15 psig.
On peak flow rates pressure does not exceed 25 psig.