Maritime Geothermal TF-45, Installation And Service Manual

Page: 45 / 89

1-Jul-2017 Page 45 001223MAN-05
Startup Record Sheet (Hydronic): TF-Series Size 45-80 Two-Stage R410a
Installation Site
Startup Date Installer
City Company
Province Model
Country Serial #
Check boxes unless asked to record data, circle units
PRE-START INSPECTION
Indoor Loop
(Hydronic)
All shut-off valve are open (full flow available)
Loop is full and purged of air
Antifreeze type
Antifreeze concentration % Volume % Weight
Loop static pressure
PSI kPa
Ground Loop
System
All shut-off valve are open (full flow available)
Loop is full and purged of air
Antifreeze type
Antifreeze concentration % Volume % Weight
Loop static pressure PSI kPa
Ground Water Water Valve installed in return line
System
Flow control installed in return line
Domestic Hot All shut-off valves are open
Water Lines are full and purged
Desuperheater pump wire is disconnected
Electrical High voltage connections are correct and securely fastened
Circuit breaker (or fuse) size and wire gauge for heat pump A Ga.
Circulator pump voltages (Outdoor 1, Outdoor 2, Indoor 1) V V V
Low voltage connections are correct and securely fastened
STARTUP DATA
Preparation Voltage across L1 and L2, L1 and L3, L2 and L3 VAC
Heating Mode Suction Pressure / Discharge Pressure psig kPa
(10 minutes)
Indoor In (Hot In), Indoor Out (Hot Out), and Delta T In Out °F °C
Outdoor In (Supply In), Outdoor Out (Supply Out), and Delta T In Out °F °C
Outdoor Flow igpm gpm L/s
Compressor L1 (black wire) current A
Domestic Hot Water functioning
Aquastat setpoint and discharge pressure at cycle end °F °C psig kPa
Final Settings S1 Setpoint, S1 Delta, S2 Setpoint, S2 Delta °F °C