34
2
nd
PART OF THE ASSEMBLY (PROTECTIVE NET)
1.
Each leg of the protective net (D) should be equipped with a rubber blind (B) as
seen in picture No. 7. Then, place on a foam cover on each of the legs (picture
No. 8).
2.
Repeat the steps and
fix all the bottom pro-
tective net legs (D),
as shown in picture
No. 10.
Subsequently, connect the bottom protective net leg (D) with the trampoline
legs, as seen in picture No. 9 below. Firstly, be sure that the net leg is touching
the ground and then perform the assembly by using clip (A) + tools (K). Do not
tighten the screw fully so you can turn the net leg as it is equipped with a latching
pin on the upper end, which should be directed outside from the trampoline. At
the end of this step, fix the buckle (A2) and screw (A3) – again, do not tighten
fully for the above mentioned reason.
No. 7
No. 8
No. 9
No. 10
D
B
Návod trampolina.indd 34
3. 8. 2017 16:34:48
