5
MIR-A
MIR-A Speaker Management
Software specification
1
1
2
2
7
7
3
3
4
4
5
5
6
6
8
8
9
9
10
10
2*20 LCD display.
Naviga on knob, responsible for the main func on switching,
menu up and down.
The P M 1 knob is responsible for turning on/off some
func ons and coarse adjustment of some values.
Input signal level meter: display the pre-fader signal, the mute
does not affect display. When the Mute light is on, it indicates
that the current channel is muted, and when the SIG light is
on, it indicates that the input signal reaches -40dBu; -12dBu,
0dBu, +6 dBu, and +12 dBu represent the actual RMS value of
the signal. When the Clip/Over light is on, it means that the
signal has been distorted before the analog-to-digital
conversion. The Limit light will be on when the input channel
compressor is ac vated.
Output signal level meter: display the post-fader signal, When
the Mute light is on, it means that the current channel is
muted, level meter does not display any value a er mute.
When the SIG light is on, it means that the input signal
reaches -40dBu; -12dBu, 0dBu, +6 dBu, and +12 dBu represent
the actual RMS value of the signal. When the Over light is on,
it means the signal reaches the Hard limiter threshold value,
the Limit light will light up when the output channel RMS
compressor and peak limiter are ac vated.
USB Type B interface, for PC connec on.
UTILITY, click to open the main menu. ESC, click to escape.
ENTER, click to next step.
The P M 2 knob is responsible for turning on/off some
func ons and fine adjustment of some values.
Input channel selec on key: Click this key to edit the
processing of the current input channel, including channel
name, gain/polarity/delay/ P E Q /compressor and other
parameters. Hold for three seconds to mute the current
channel.
Output channel selec on bu on: Click this bu on to edit the
processing of the current input channel; include input
channel matrix rou ng, high and low pass filter frequency,
slope, filter type; also include gain/polarity/delay/parametric
equaliza on /RMS compressor/peak limiter/hard limiter and
other parameters. Hold for three seconds to mute the current
channel.
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
10
10
4.3.Overview of the processor front panel
Summary of Contents for MIR-A Series
Page 1: ...MIR A Speaker Management Systems MIR A Series User Manual software v0 3 3 REVISION A1 DEC 2021...
Page 2: ......
Page 59: ......
Page 60: ......
