Marani MIR-A Series, User Manual

Page: 35 / 60

The same applies to dual-channel, that is, two
channels can be applied with plug-ins, and the
corresponding FIR with a sampling rate of 96KHz
needs to be used, and the FIR generated by a third
party can be imported here (Note: the FIR filter of
the input and output channels runs at 48kHz
sampling rate, the audio stream is processed by FIR
through down-sampling, and then up-sampled back
to the D S P processing chain. Similarly, the F I R
convolu on generated by AEQ is also running at a
sampling rate of 48kHz, so here 96kFIR can only be
imported from the file).
When selec ng RTA and advanced signal generator.
The signal generator and RTA icons will appear.
This is the main interface when the advanced
generator and RTA are not selected.
33
MIR-A
MIR-A Speaker Management
Software specification
7 7
Advanced generator Provides a choice of
insert posi on, which can be selected
before the input channel processing (a er
A/D), a er the input channel processing, or
o u t p u t ( b e fo re D /A ) , w h e n t h e i n p u t
channel is selected a er processing, or
output (before D/ A) , when select INPUT
P R E- P R O C ,there are two noises: pink
noise/white noise.
Sgn Gen
When selec ng input post EQ or output, different
filter types can be selected, including filtered white
noise, filtered pink noise, sine wave, sweep sine
wave, etc., which can only be sent to 1 channel of the
input/output, The level range is -30dBu to +10dBu.