Cursor
: clicking on this control, cursors will appear on the graphic showing the amplitude response of
the parametric Eq, for the setting of the filters' gain by mouse action.
View All
: this control is opening a window showing the full Eq setting on each Input or Output or
combination of them.
Mag and Phase
: it is possible to decide if showing on the Window's graphic the Magnitude response
of the Parametric Eq setting (Mag selected) or the Phase response (Phase selected).
Delay
: the Input delay can be set here. The delay (in ms or meter) can be set using the button
up/down “Adj” with step 1ms or “Fine” with step 10.4us (max input delay = 480ms =163.5meter)
RMS Compressor
: the
LPP240A
is implementing a powerful RMS compressor on Inputs and Outputs,
which compression coefficient is calculated on the base of tabled values giving a compression step of
0.2dB.
-
Bypass
: Compressor Active or not (Note that the all parameters here below are not accessible when
the Compressor is set in Bypass)
-
Threshold:
from -10dBu to +20dBu step 0.2dBu
-
Ratio
: [input:Output] from 2:1 to 32:1 step 1
-
Knee
: from 0% to 100% (0% hard knee, 100% soft knee
-
Release
-time: from 0.001sec to 10sec step 0.001 sec
-
Attack
-time: from 0.1ms to 5000ms step variable
- M
ake-Up
: from -12dB to +12dB step 0.1dB
Noise Gate
: a noise gate is available
-
Bypass
: Noise Gate Active or not
-
Threshold:
from --80dBu to -50dBu step 5dBu
-
Release
-time: from 10ms to 1sec step variable
-
Attack
-time: from 1ms to 1sec step variable