Operator’s Manual
Self-Propelled Scissor Lift
Version1
30
7.4 Operation From the Ground
CAUTION
Only use the ground control panel as an emergency control. Always use the platform
controller as standard operation control.
1. Turn the key switch of the ground control panel to ground position.
2. Turn out the Emergency Stop buttons of the ground control panel and platform controller to the
ON
position.
To Position Platform
Move and hold the platform up/down switch according to the markings on the control panel.
Drive and steering functions are not available from the ground control panel.
7.5 Operation From the Platform
WARNING
Personnel in the platform must wear a Personal Fall Protection Equipment (PFPE).
Attach the PFPE to one of the anchor points of the platform before operating.
1. Install the platform controller in its storage position (front right) on the platform guard rails.
Note
: A protection case was built around the platform controller to protect the platform controller from
possible damage and is also used to easily install the platform controller in its storage position.
2. Connect the AC wiring connector of the platform controller to the electrical connector on the
platform.
3. Turn the key switch of the ground control panel to platform position.
4. Turn out the Emergency Stop buttons of the ground control panel and platform controller to the ON
position.
To Enter The Platform
For machines equipped with entry gate
1. Push the lever and open the platform entry gate.
2. Use the entry ladder to enter the platform.
3. Close the platform entry gate and use the lever to lock it.
For machines equipped with entry bar
1. Push the platform entry bar completely up.
2. Use the entry ladder to enter the platform.
3. Completely lower the platform entry bar.
