Mannesmann ecodrive03, Troubleshooting Manual

Page: 119 / 128

ECODRIVE03 SMT-02VRS Index
7-3
DOK-ECODR3-SMT-02VRS**-WA01-EN-P
G
Gain adjustment failed 4-29
H
Homing of absolute encoder not possible 4-19
Homing only possible with drive enable 4-19
I
ID9 + Record length - 1 > length MDT (S-0-0010) 4-8
Incr. encoder emulator
pulse frequency too high 3-12
Incremental encoder required 4-26
Inertia detection failed 4-29
Input master password 4-25
Input value for max. range too high 4-16
Interpolation acceleration = 0 3-27
Interpolation velocity = 0 3-26
Invalid addressing of AT-data container A 3-34
Invalid addressing of MDT-data container A 3-34
Invalid amplifier data (->S-0-0022) 4-12
Invalid communication parameter (S-0-0021) 4-5
Invalid communication phase shutdown 3-16
Invalid feedback data (->S-0-0022) 4-11
Invalid parameter(s) (->S-0-0022) 4-10
J
Jb 4-42
JF 4-42
JOG mode negative 4-38
JOG mode positive 4-38
L
Length of MDT (S-0-0010) odd 4-7
Limit error communication parameter (S-0-0021) 4-5
Load-side motor encoder with inductance motor only 4-17
Locked with password 4-22
Low battery voltage 3-11
M
Mains fault 3-15, 3-34, 3-38
Master password required 4-3
Max signal frequency of encoder 2 exceeded 3-11
Max. signal frequency of encoder 1 exceeded 3-7
Maximum braking time exceeded 3-6
Modulo range error 4-16
Motion range exceeded during commutation 3-20, 4-25
Motor does not have resolver feedback 4-2
Motor feedback data not valid 4-28
Motor overload 3-26
Motor overtemp. prewarning 3-28
Motor overtemp. shutdown 3-4
Motor tauschen 5-4
Motor temp. surveillance defective 3-5
Motor type P-0-4014 incorrect 4-11
N
Negative limit switch activated 3-38
Negative position limit exceeded 3-36
Negative travel limit exceeded 3-18
Negative travel limit switch detected 3-19
No adjustment with asynchronous motor 4-24
No ready signal from supply module 3-15, 3-34, 3-38