Manitou MH20-4 T BUGGIE 4ST3B, Operator'S Manual, Page: 86 / 114

3-22
E - EVERY 1000 HOURS SERVICE OR EVERY TWO YEARS
Carry out the operations described previously as well as the following operations.
E1 - FUEL TANK
CLEAN
While carrying out these operations, do not smoke or work near a flame.
Place the lift truck on level ground with the I.C. engine stopped.
- Inspect the parts susceptible to leaks in the fuel circuit and in the tank.
- In the event of a leak, contact your dealer.
Never try to carry out a weld or any other operation by yourself, this could provoke an explosion or a fire.
- Place a container under drain plug 1 (fig. E1/1) and unscrew the plug.
- Remove filling plug 2 (fig. E1/2) in order to ensure that the oil is drained properly.
- Rinse out with ten liters of clean diesel through filler port 3 (fig. E1/2).
- Refit and tighten the drain plug (tightening torque 29 to 39 N.m).
- Fill the fuel tank with clean diesel filtered through the filler port.
- Refit the filling cap.
E2 - SAFETY DRY AIR FILTER CARTRIDGE
CHANGE
- For the disassembly and reassembly of the dry air filter cartridge, see: 3 - MAINTENANCE: D3 -
AIR FILTER CARTRIDGE.
- Gently remove the dry air filter safety cartridge 1 (fig. E2), taking care to avoid spilling the dust.
- Clean the gasket surface on the filter with a damp, clean lint-free cloth.
- Before mounting, check the state of the new safety cartridge (see: 3 - MAINTENANCE: FILTERS
AND BELTS).
- Introduce the cartridge into the filter axis and push it in, pressing the edges and not the middle.
NOTE: The periodicity for changing the safety cartridge is given for information only. It must be
changed for every two changes of the dry air filter cartridge.
E3 - HYDRAULIC OIL
DRAIN
E4 - SUCTION STRAINER FOR HYDRAULIC OIL TANK
CLEAN
E5 - FILTER CAP FOR HYDRAULIC OIL TANK
CHANGE
Put the lift truck on level ground, the I.C. engine stopped and the mast lowered as far as possible.
Before any intervention, thoroughly clean the area surrounding the drain plug and the suction cover on the
hydraulic tank.
DRAINING THE OIL
- Lift up the overhead guard or the cab (see : 2 - DESCRIPTION : INSTRUMENTS AND CONTROLS).
- Place a container under drain plug 1 (fig. E3/1) and unscrew the plug.
- Remove filler cap 2 (fig. E3/2) in order to ensure that the oil is drained properly and get rid of it.
Dispose the drain oil in an ecological manner.
E1/1
1
E1/2
2
3
E2
1
E3/1
1
647448
(20/05/2015)