Manitou 200 ATJ, Operator'S Manual

Page: 103 / 138

3 - 13
C4 - A
LTERNATOR
/ F
AN
/ C
RANKSHAFT BELT TENSION
ADJUST
- Open the left-hand cover.
- Check the tension of the belt between the fan and alternator pulleys.
- When pressed normally with your thumb (45N), the tension should be
around 10mm.
- Adjust the belt if necessary.
- Loosen the screws 1 (Fig. C4) two or three turns.
- Pivot the alternator assembly to achieve the required belt tension.
- Retighten the screws 1 (Fig. C4) (tightening torque 22Nm).
- Check the belt's condition for signs of wear or cracking and replace it
if necessary.
If the alternator belt has to be changed, check the tension again
after the first 20 hours of operation.
C5 - O
IL LEVEL IN FRONT AND REAR WHEEL REDUCERS
CHECK
Set the platform on a horizontal surface with the engine stopped.
DIFFERENTIAL :
- Remove the plug 1 (Fig C5/1). The oil level must be flush with the hole.
- Add oil if necessary (see the LUBRICANTS section) through the same
hole.
- Re-insert and tighten the plug 1 (Fig. C5/1) (tightening torque 6 daNm).
AXLES :
- Remove the plug 2 (Fig C5/2: front axle) (Fig. C5/3: rear axle). The oil
level must be flush with the hole.
- Add oil if necessary (see the LUBRICANTS section) through the same
hole
- Re-insert and tighten the plug 2 (Fig C5/2: front axle) (Fig. C5/3: rear
axle) (tightening torque 6 daNm).
C4
1
1
1
C5/1
1
C5/2
C5/3
2
2