Manitou 200 ATJ, Operator'S Manual

Page: 99 / 138

3 - 9
The fuel tank is degassed via the filler plug. When changing it, always
use an original part, with degassing hole.
A4 - B
RAKING
CHECK
Make sure there are 4 screws 1 (Fig. A4/1) and 2 (Fig. A4/2) on the rear axle
assembly.
Check their position regularly. If the screws are not tight enough
THE MACHINE WILL HAVE NO BRAKES.
A5 - H
YDRAULIC OIL LEVEL
CHECK
Set the platform in transport position on a horizontal surface with the engine
stopped.
- The oil level must be checked at ambient temperature between 10°C and
20°C; it must reach the middle of indicator 1 with a tolerance of ±1 cm
(Fig. A5)
- If necessary, add oil (See chapter on "LUBRICANT") through filler hole 2
(Fig. A5).
The hydraulic oil level must be checked with the pendular arm
in low position
A6 - C
ONDITION OF MANIPULATOR BOOTS
CHECK
For this operation, get into the basket with the internal combustion engine off.
- Check the condition of the manipulator rubber boots 1 (Fig. A6) by moving
them as if during a normal movement.
The boots must not be split or cracked ; risk of water infiltrating which would
prevent the machine from working properly.
A7 - C
ONDITION OF WHEELS AND TYRES
CHECK
Check the tyres for any cuts, tears, protuberances,.. wear, etc
A4/1
A4/2
A5
A6
1
1
1
2
2
1
22 mm