Manitou 200 ATJ, Operator'S Manual

Page: 112 / 138

3 - 22
D10 - T
IGHTENING TURRET ROTATION MOTOR BOLTS
CHECK
Set the platform on a horizontal surface with the engine stopped.
- Check the tightness of the nine bolts 1 (Fig. D10).
- The tightening torque for the bolts is 8 daN.m ± 10%.
- 1 daN = 1 Kg
D11 - T
URRET MOTOR BRAKE REDUCER
EMPTY - REPLACE
Set the platform on a horizontal surface with the engine stopped.
- Remove the turret's interior cover.
- The gear motor is revealed with the valve block facing to the back.
- Remove the filling-breather cap 2 (Fig. D10) to ensure good drainage.
- Mark the drain plug 3 located on the bottom of the reducer unit on the
right-hand side (Fig. D11).
- Place a small receptacle to catch the oil.
- Loosen the drain plug.
Dispose of the oil in an envirinmentaly friendly manner.
- Use a syringe to fill the reducer via the filling-breather cap 2 (Fig. D10). The
level is correct when the breather is full of oil.
- Re-insert the filling-breather cap 2 (Fig. D10)
D12 - T
IGHTENING CARDAN BOLTS
CHECK
Set the platform on a horizontal surface with the engine stopped.
- Check the tightness of the eight bolts (four on each end) 1 (Fig. D12/1)
and 2 (Fig. D12/2).
- The tightening torque for the bolts is 8 daN.m ± 10%.
- 1 daN = 1 Kg
D10
2
1
D11
3
D12/1
1
1
D12/2
2
2