Manitou 160 ATJ PLUS Euro 3, Instruction Manual

Page: 119 / 146

3-19
C3
C3 - FRONT AND REAR WHEEL REDUCER OIL LEVEL
CHECK
Set the lifting platform on a horizontal surface, with the engine switched off.
- Check the level in each of the front wheel reducers.
- Set the level plug 1 (Fig. C3) horizontal.
- Remove the level plug; the oil level should be flush with the hole.
- If necessary, top up the oil through the same hole (see the LUBRICANTS section).
- Refit the level plug 1 and tighten it (Fig. C3 (tightening torque: 8 daNm)
- Perform the same operation on each of the rear wheel reducers.
C4 - TIGHTENING THE WHEEL NUTS
CHECK
- Check the tightness of the wheel nuts (Fig. C4).
Failure to observe this instruction may cause the wheel pins to be
damaged and break, as well as the wheels to deform.
C5 - EMERGENCY PUMP
CHECK
- Switch off the engine.
Check that the emergency pump is operating correctly by pressing the switch on the
side of the base control box or the basket control box.
- Perform an arm lowering movement (example...)
You must not use the lifting platform under any circumstances if the
pump is not working.
C6 - TELESCOPE ADJUSTMENT
CHECK
- Check the tightness of the 16 nuts on the telescope skids 1 (Fig. C6/1 and C6/2).
Failure to observe this instruction may result in loss of the skids and
damage to the telescope.
WHEEL NUT
TIGHTENING TORQUE
FRONT
WHEELS
34 daN.m
± 15 %
REAR
WHEELS
34 daN.m
± 15 %
C4
C6/1
C6/2
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
547408 EN (15/05/2012)