Mamas & Papas Pliko combination, Manual

Page: 11 / 19

– 21 – – 20 –
ATTACHING THE NAVETTA HOOD
To fit the Navetta hood to
the pushchair:
Remove the hood from the
Navetta following the
instruction given in the
products instruction booklet.
Slot the two hood brackets
onto the ends of the hood as
shown.
REMOVING THE HOOD
Fasten the three press studs
on the back of the hood to the
three studs on the top of the
pushchairs backrest.
Push the two tensioning bars
down to lock the hood open.
Slot the hood brackets onto
the pushchairs frame as shown
in the diagram.
Undo the zip on the back of
the hood to increase the hood
length.
To remove the hood:
Undo all of the press studs and
fold the tensioning bars
upwards.
Hold the hood brackets as
shown in the diagram and pull
outwards from the pushchair.
FOLDING THE PUSHCHAIR
Ensure that the two locking
catches below the finger
catches lock over the clips on
the rear leg attachment
moulding, as shown in the
diagram.
Engage the brakes before
closing the pushchair.
Pull one of the finger catches
upwards until it locks into
position, then repeat for the
other finger catch.
Grip the handle in the centre
of the backrest and pull it
upwards as shown in the
diagram.
Continue to pull the handle
upwards until the pushchair is
fully folded.
WARNING: Do not push down vertically on the frame when folding. This
will cause the ends of the handles to hit the floor and may damage the
frame.