Push the two attachment
brackets down until they click
into place on the braces.
Check they are fully attached
by attempting to pull them
out again
Fasten the sides of the cover
to the chassis armrests as
shown in the diagrams.
Insert the levers for the
legrest into the pockets in the
cover as shown in the
diagrams.
Fasten the front of the cover
to the chassis using the press
studs.
Slot the end of the crotch
strap through the seat cover
and the seat of the chassis.
Feed the waist sections of the
safety harness around the
sides of the cover.
A
A
B
– 13 –
CONVERTING THE CHASSIS INTO A PUSHCHAIR
The Pliko combination can be
used in either the chassis
mode or the pushchair mode.
This section shows how to fit
the cover and backrest.
Ensure that the two levers on
the back frame are lowered
as shown in the diagram.
Place the cover and backrest
onto the seat of the chassis
as shown in the diagram.
Insert the two ends of the
backrest into the attachment
brackets at the back of the
chassis. Press the buttons on
the ends of the backrest
inwards (
1
) and fully insert
the backrest into the
attachment brackets (
2
).
Attach the backrest adjusters
to the rear legs of the
chassis. Turn the attachment
brackets on the backrest
adjusters upwards (A).
Align the attachment brackets
with the braces on the
pushchairs rear legs (B).
A
B
1
2
– 12 –
Summary of Contents for Pliko combination
Page 19: ... 36 Notes ...
