Maktek 25 MKP, Operating And Using Manual

Page: 16 / 25

6. FULL AUTOMATIC PELLET BOILER CONTROL PANEL
16
LCD SCREEN
On / Off
Alarm Off Load Fuel
Temprature Setting
Fan Setting
Fuel Loading Time (sec)
Fuel Waiting Time (sec)
On – Off – Reset
Button
It is on off button of the boiler. It is used as reset button in failures .
It must be held down for 2 seconds to switch on, off and reset.
Fuel Loading
It is used for manuel preloading by only services while first starting (Users shouldn't do
preloading)
Temperature
Setting
To increase or decrease the boiler temperature, press once on the button and adjust
with increase and decrease buttons.
Fan Setting To adjust the fan speed, press the button once and adjust with the increase and
decrease buttons.
Fuel Loading
Time (sec)
If the factory settings do not adequate, press the button once to change the fuel
loading values and adjust with the increase and decrease buttons.
Fuel Waiting
Time (sec)
If the factory settings do not adequate, press the button once to change the fuel
waiting values and adjust with the increase and decrease buttons.
Increasing Button Enter the menu which is desired to be changed and use this button to
increase the value.(Which situation is to be used first must be pressed on
that button.)
Reducing Button Enter the menu which is desired to be changed and use this button to
reduce the value. (Which situation is to be used first must be pressed on
that button.)
Close the Alarm The boiler gives a sound alert in case of a failure or when the fuel is finished .
Button must be pushed once to close the sound. (Use the reset button to remove it
from the fault.)
Data Screen An LCD screen that allows to monitor the boiler's running equipment and set values.
ERROR CODES
H1 No Fuel
H2 Fuel Clogged
H3 Sensor Error
H4 High Boiler Temp e rature
H5 Burning Error
H6 High Fuel Pipe Temp e rature
H7 Ignition Error
H8 Chimney Sensor Error
H9 High Chimney Temp e rature
H10
Fan Error
H11 High Water Temp e rature
IMPORTANT!!!
When no setting is made to the
digital display, the value read
shows the boiler water
temperature at that time.