20
Enter the “Width” value by using “+” and “-“
keys. Press the “ACCEPT” button after entering
the width value and convert the frame into
yellow.
To enter the determined length dimension
place the yellow frame on “Length” by using
“+” and “-“ keys. Press the “ACCEPT” button to
convert the yellow frame to green.
Enter the “Length” value by using “+” and “-“
keys. Press the “ACCEPT” button after entering
the length value.
Press the “SCAN “ button after this operation
and pass over the target again and release the
“SCAN” button
After this operation the device presents an
“Analysis Report” that indicates whether the
target is METAL or CAVITY, entered dimension
values and environmental effects.
Press the “ACCEPT” button to leave this
report.
Switched back to Depth mode and switched to
explore mode by pressing the “DEPTH” button.
Summary of Contents for JeoScan 2D system
Page 1: ......
Page 3: ...2 WARNING PLEASE DO NOT START ASSEMBLING OR USING BEFORE READING THE WARNINGS SECTION...
Page 24: ......