9
USING THE LCD MODE
NOTE:
The LCD system function of the device can only be used when 360x440mm search
coil and 600x1000mm search coil is installed. Install the 360x440mm or 600x1000mm
search coil to the system box as described in the “assembly” section.
The device has two separate systems. One of these systems is the
LED
System
, the other is
LCD System
. To switch the device to LCD System,
the commutator switch is adjusted to LCD.
After the device is switched on the operator makes
the desired language selection by using “+” and “-“
keys and press “ACCEPT” button to finalize the
language selection.
When the device is on the LCD mode the screen
system is enabled and the device detects the
installed search coil and prepares for that search
coil. If no search coil is installed on the device a
warning is displayed on the screen.
Coil and System Error Warnings:
If there is an error in the search coil or in the system
“SEARCH COIL FAULT” or “SYSTEM FAULT” warning
lights blink at the bottom of the screen and a sound
alarm is heard to warn the operator after the device
is switched on. In this case the operator should
switch off the device, check the connectors and
witch on the device again. If the warning persists authorized service should be called.
Summary of Contents for JeoScan 2D system
Page 1: ......
Page 3: ...2 WARNING PLEASE DO NOT START ASSEMBLING OR USING BEFORE READING THE WARNINGS SECTION...
Page 24: ......